Animal Print Pattern Stretch PU HTV Instructions

Animal Print Pattern Stretch PU HTV

Transfer/Application Instructions

 

Step 1: Weed & Cut:

  1. Make sure your design in cut in reverse.
  2. Cut out the pattern. Make sure to lay the htv on mat with shiny firm plastic side down.
  3. Weed out the excess material.


Step 2: Heat and Transfer:

Home Iron:

  • Medium setting (302°F– 320°F)
  • Medium/firm pressure (about 10 lbs) for 10-15 seconds


Heat Press:

  1. Preheat garment for 2-3 seconds
  2. Apply design to desired fabric; 305℉
  3. Medium pressure for 10-15 seconds

Step 3: Cool Peel

Allow the design to cool for 15 to 30 seconds and then gently peel of the carrier sheet.

*If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl.

Special Note: The htv is divided into three layers, the outermost layer is a protective film, bubbles and slight creases may occur and will not affect the use.