PVC HTV Application Instructions

PVC HTV

Transfer/Application Instructions

 

Step 1: Weed & Cut:

  1. Make sure your design in cut in reverse/mirror.
  2. Cut out the design. Make sure to lay the htv on the mat with shiny film plastic side down.
  3. Weed out the excess material.


Step 2: Heat and Transfer：

Heat Press:

  1. Preheat garment for 2-3 seconds
  2. Apply design to desired fabric 150-160c
  3. Press medium pressure for 10 seconds

Step 3: Warm Peel

Allow the design to cool a little and then gently peel of the carrier sheet.

*If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl.

*Please note that actual colours shown on this page may differ slightly to those you receive due differences in lighting, flash and screen resolution.