UV Sticker Application

Step 1: Clean and Prep
Wash your cup with soap and dry completely. DO NOT USE ALCOHOL as it will break down the adhesive. Make sure the surface is free of dust and debris. Cut off any excess clear carrier sheet prior to application to avoid overlapping.

Step 2: Position and Secure
Peel the backing just about an inch, then use scissors to cut 1/2 inch of the backing, exposing the adhesive. Using the unexposed part of the decal, wrap it around your cup and position it carefully. Be extra careful not to push the adhesive area you have left exposed. Once you are happy with the placement, gently push down the exposed adhesive to secure the position. Place the cup on the hard, straight surface, then start peeling the backing as you roll the cup. Once the decal is on the cup, take time to push the decals onto the surface. I usually push between 3-5 minutes with my palm, using body temperature to activate the UV DTF adhesive. Doing this will make your peeling step so much easier, and decals will have less lifting. Transfer is NOT removable or adjustable once it is applied to a surface.

Step 3: Remove Backing
SLOWLY, very slowly peel off the backing paper from the decal, ensuring it doesn't stretch or tear. If any part of the design lifts up as you peel, go back, gently push down on that area, and then resume peeling.

Step 4: Smooth It Out
Use your fingers or palms to smooth out the decal starting from the center and moving outward.

Step 5: Activate
DO NOT wash or use the finished project for 24-48 hours to allow the adhesive to strengthen on the glass.

Important Information:

  • Do not use sublimation glasses—especially the frosted ones—simply because the wrap won’t stick.
  • Please do not use alcohol as it breaks down the adhesive and prevents it from sticking to the glass surface.
  • Once the application process begins and the adhesive touches the glass, it is NOT removable or adjustable. (This is standard with UV DTF decals).